Bevel cutting
CAUTION:
Always remove the battery from the tool before making any adjustments
With the base tilted, you can make bevel
cuts at any angle between 0" and 45" (left
or right). Loosen the bolt on the bottom of
the tool. Move the base so that the bolt is
positioned in the center
of
the cross-shaped
slot in the base.
Tilt the base until the desired bevel angle
is obtained. The edge of the motor housing
indicates the bevel angle by graduations.
Then tighten the bolt to secure the base.
Flush cutting
Loosen the bolt on the bottom of the tool
and slide the base all the way back. Then
tighten the bolt to secure the base.
Cross-shaped slot
Edge
of motor housing
r l
I
11