Brother DCP-9020CDN User Manual page 94

Error Message
Fuser Error
Jam 2-sided
Jam Inside
Jam Manual Feed
Jam Rear
Jam Tray
Limit Exceeded
Log Access Error
Manual Feed
No Belt Unit
No Permission
No Paper
86
Cause
The temperature of the fuser
unit does not rise to a specified
temperature within the
specified time.
The fuser unit is too hot.
The paper is jammed
underneath the paper tray or
the fuser unit.
The paper is jammed inside the
machine.
The paper is jammed in the
manual feed slot of the
machine.
The paper is jammed in the
back of the machine.
The paper is jammed in the
paper tray of the machine.
The number of pages you are
allowed to print has been
exceeded. The print job will be
cancelled.
The machine could not access
the print log file in the server.
Manual was selected as the
paper source when there was
no paper in the manual feed
slot.
The belt unit is not installed
correctly.
Printing colour documents is
restricted by Secure Function
Lock 2.0. The print job will be
cancelled.
The machine is out of paper in
the paper tray, or paper is not
correctly loaded in the paper
tray.
Action
Press and hold down
off, wait a few seconds, and then turn it on
again. Leave the machine idle for 15 minutes
with the power on.
See Paper is jammed underneath the paper
tray on page 99.
See Paper is jammed inside the machine
on page 96.
See Paper is jammed in the manual feed slot
on page 92.
See Paper is jammed at the back of the
machine on page 94.
See Paper is jammed in the paper tray
on page 92.
Contact your administrator to check your
Secure Function Lock Settings.
Contact your administrator to check the Store
Print Log to Network settings.
For more information, see Network User's
Guide: Store Print Log to Network
Place paper in the manual feed slot (see
Loading paper in the manual feed slot
on page 20).
Reinstall the belt unit (see Replacing the belt
unit on page 58).
Contact your administrator to check your
Secure Function Lock Settings.
Do one of the following:

Refill paper in the paper tray. Make sure the
paper guides are set to the correct size.

Remove the paper and load it again. Make
sure the paper guides are set to the correct
size.
to turn the machine