Uncap the charging connector hole.
Connect the charging plug to the charging
connector, then plug in the charger to the
power receptacle. Charging takes
The battery in your new tool is not fully
charged. You will need to charge it
Do not operate the tool during charging.
Overcharging more than 2 days
considerably shortens the battery service
life. Always unplug the charger after
completing the charge. Then cap the
charging connector hole.
When you charge a new tool or a tool which has not been used for a long period, it may
not accept a full charge. This is a normal condition and does not indicate a problem. You
can recharge the tool fully after discharging it almost completely a couple of times.
Nominal Diameter (mm)
Selecting correct Phillips bit
Use the chart to determine the best size
driver bit for the size of screw that you wish to
Selecting slotted bit
Use a slotted bit that properly fits the screw
slot. Use of a bit that is too small will damage
the screw and/or bit.