Installing Memory Modules - Dell PowerEdge 6850 System Installation Manual

Hide thumbs Also See for PowerEdge 6850:
Table of Contents

Advertisement

 
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as
authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not
authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
 
1. Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
 
2. Open the system. See
"Opening the
 
3. Remove the memory riser card:
a.  Press in the release tab on the riser card handle. See Figure 6-13.
b.  Lift up the riser card handle and pull the riser card straight up.
c.  Remove the plastic riser-card insulator. See
 
4. Add, remove, or replace a memory module, and then replace the insulator. See
 
5. Install the memory riser card:
a.  Ensure that the riser-card handle is fully extended, and then align both edges of the riser card with the front and rear riser-card guides. See
Figure 6-13.
b.  Lower the riser card until the riser card connector is near the riser-card connector on the system board.
c.  Ensure that both connectors are properly aligned, and then gently press the riser card until it is fully seated.
d.  Press down the riser-card handle until its release tab locks into place.
 

Installing Memory Modules

 
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as
authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not
authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
 
1. If you are installing memory in a hot-pluggable memory operating environment, remove the memory riser card as described in
a Hot-Pluggable Memory Riser
If you are installing memory in a non–hot-pluggable memory operating environment, remove the memory riser card as described in
Installing a Non–Hot-Pluggable Memory Riser
 
2. Locate the memory module sockets. See Figure A-3.
 
3. Press the ejectors on the memory module socket down and out, as shown in Figure 6-14, to allow the memory module to be inserted into the socket.
 Figure 6-14. Installing and Removing a Memory Module
 
4. Align the memory module's edge connector with the alignment key on the memory module socket, and insert the memory module in the socket.
NOTE:
The memory module socket has an alignment key that allows you to install the memory module in the socket in only one way.
 
5. Press down on the memory module with your thumbs while pulling up on the ejectors with your index fingers to lock the memory module into the socket.
When the memory module is properly seated in the socket, the ejectors on the memory module socket align with the ejectors on the other sockets that
have memory modules installed.
 
System" in "Troubleshooting Your System."
"Removing a Memory Riser Card
Card."
Card."
Insulator."
"Installing Memory
Modules" or
"Removing Memory
Modules."
"Removing and Installing
"Removing and

Advertisement

Table of Contents
loading

Table of Contents