Pressing excessively on the tool will not speed up the drilling. In fact, this excessive pres-
sure will only serve to damage the tip of your bit, decrease the tool performance and
shorten the service life of the tool.
-There is a tremendous force exerted on the tool/bit a t the time of hole breakthrough.
Hold the tool firmly and exert care when the bit begins to break through the workpiece.
.A stuck bit can be removed simply by setting the reversing switch to reverse rotation in
order to back out. However, the tool may back out abruptly if you do not hold
Always secure small workpieces in
or similar hold-down device.
Place the point of the driver bit in the screw head and apply pressure to the tool. Start
the tool. Release the switch trigger just
the screw bottoms out. If the switch trigger
not released, the screw may strip out the hole or the screw and/or bit may be damaged.