Download Print this page

Makita 601D Instruction Manual page 8

10 mm (3/8") battery-powered driver dril

Advertisement

Charging
Connect the battery to the charger using the adaptor cord. Then plug the charger into the
power source. The charging light will illuminate and charging will begin. When the charg-
ing light goes out a t a certain time, the charging is complete. Unplug the charger.
(Note: Refer to the table below for the charging time.)
DC122
DC121
122
3
\
Approx. 1 hour
Approx. 2 hours
Outlet
F
u
r
c
o
r
d
7
121
Charger
r C h a r g i n g , l i g h t
-Connector
ADDrox. 2 hours
ADDrox. 4 hours
CAUTION :
0
Always charge the Makita battery 122 immediately after purchase.
*Always recharge the Makita battery 122 after use.
If the Makita battery 122 has not been used for long periods, charge
it
for more than the
time specified in the table above. (Example: If it has not been used for six months, charge
it for approx. one week.) Charging continues even after the charging light goes out. If the
battery i s left uncharged for more than six months, it may become unchargeable. If the
light does not come on within five minutes after you start the charging, the battery may
be unchargeable. Ship or take the charger and the battery to your nearest Makita Service
Center or Distributor for checking.
8

Advertisement

loading

This manual is also suitable for:

601dst