Frequently Asked Questions; Technical Problems - Miele PG 8056 Operating Instructions Manual

Frequently asked questions

With the help of the following guide, minor faults in the performance of the appliance,
some of which may result from incorrect operation, can be corrected without contacting
the Service Department.
Please note that a call-out fee will be applied to unnecessary service visits where the
problem could have been rectified as described in these operating instructions.
 Repair work to electrical appliances must only be carried out by a suitably qualified
person in strict accordance with current local and national safety regulations. Repairs
and other work by unqualified persons could be dangerous. The manufacturer cannot be
held liable for unauthorized work.

Technical problems

Problem
When the dishwasher is
turned on with the 
button, the display stays
dark and the Start/Stop
indicator does not flash.
The dishwasher stops
during a program.
One of the following fault
messages is displayed:
Check water intake
Fault 403-405
94
Possible cause and solution
The dishwasher is not plugged in.
Insert the plug.

The circuit breaker has tripped.
Reset the circuit breaker

(minimum fuse rating - see data plate).
The circuit breaker has tripped.
Reset the circuit breaker (see data plate for the correct

fuse rating).
If the circuit breaker trips again, contact Miele Customer

Service.
Before fixing the fault:
Turn the dishwasher off with the  button.

There is a problem with the water intake.
Open the faucet all the way.

Clean the filter in the water inlet (see "Cleaning and

care").
If Check water intake
is checking the water intake approx. every 30 seconds. If,
after three attempts, water is not getting into the
dishwasher, one of these numbers will appear in the display
and the program will be cancelled.
Open the faucet all the way.

Turn the dishwasher back on.

Select the desired program.

Press the Start/Stop button.

appears in the display, the control unit