Programming; Batch Settings - Fetco CBS-2031ee User Manual

Batch Settings

Turn the brewer off by pressing the power switch.
Press and hold the power switch until the display reads P r G.
The left side STOP button will illuminate.
Quickly press the STOP button.
The display will show the software version. Example:
Press STOP to continue.
Batches are numbered 1 – 2 (single side) or 1 – 4 (dual side)
Next, the first batch parameter is displayed – batch 1, brew volume
Use the SCROLL UP and SCROLL DOWN buttons to adjust.
Press the STOP button to go to the next parameter – brew time.
Continue this way until all parameters are programmed for batch #1.
(See the chart below for an explanation of each parameter.)
Next, batch #2 programming begins.
Batches 2 and 4 may be disabled by leaving them set to "OFF".
Change to "ON" to enable. Batches 1 and 3 cannot be disabled.
After all batches are programmed, go to temperature settings.
Important! After programming, you must press and hold the STOP button until the display reads STO to save the
settings and exit programming mode, or changes will be lost. You may exit programming at any time.
Batch Parameters
X=Batch Number (1 - 4)
Parameter Name
X.0 Batch Enabled or
Disabled
X.1 Brew Volume:
CBS-2031ee/2032ee
CBS-2041ee/2042ee
X.2 Brew Time (Min:Sec)
X.4 Prewet Percent
X.5 Prewet Delay
(Min:Sec)
X.6 Drip Delay (Min:Sec)
CBS-2031ee/2032ee
CBS-2041ee/2042ee

Programming

BATCH #
1.1 1.00
Example: Left Side – Large Batch – Volume 1.0 Gal.
Range
On/Off
0.94 – 4.72
0.25 – 1.25
2:00 – 9:30
0.00 – 15.0%
0:10 – 5:00
0:30 – 6:00
0:30 – 6:00
PARAMETER
SETTING
(See next page)
Increment Default Setting
Batch 1 & 3 = ON
Batch 2 & 4 = OFF
0.01 2.49 liters
0.01 1.0 gallons
0:30 4:00 minutes
1% 0 %
0:10 1:00 minute
0:10 1:00 minute
0:10 1:30 minute
9
Display
P r G
0.0 03.L
1.1 1.00
1.2 4.00
2.0 OFF
7 200
Comment
Batch 1 & 3 cannot
be disabled.
To change setting to
liters or gallons, see
# 59 in Advanced
Settings section.
Percentage of total
brew volume
The time between
prewetting and start
of brew cycle.
The time between
end of brew cycle
and unlocking of
brew basket.