Safety Instructions - Hisense Essense User Manual

Safety instructions

To guarantee the unit work normally, please read the manual carefully before installation,
and try to install strictly according to this manual.
Do not let air enter the refrigeration system or discharge refrigerant when moving the
air conditioner.
Properly ground the air conditioner into the earth.
Check the connecting cables and pipes carefully, make sure they are correct and firm before
connecting the power of the air conditioner.
There must be an air-break switch.
After installing, the consumer must operate the air conditioner correctly according to
this manual,keep a suitable storage for maintenance and moving of the air conditioner
in the future.
Fuse of indoor unit: 3.15A 250V.
For 9k,12k models ，f
use of outdoor unit: 15A 250V or 20A 250V .
For 18k models ，f
use of outdoor unit: 20A 250V .
For 24k,30k,24k*;30k* models ，f
use of outdoor unit: 30A 250V .
A residual current device(RCD)with the rating of above 10mA shall be incorporated in
the fixed wiring according to the national rule
Warning: Risk of electric shock can cause injury or death: Disconnect all remote electric
power supplies before servicing .
The maximum length of the connecting pipe between the indoor unit and outdoor unit
should be less than 5 meters. It will affect the efficiency of the air conditioner if the
distance longer than that length.
This appliance can be used by children aged from 8 years and above and persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge if
they have been given supervision or instruction concerning use of the appliance in a
safe way and understand the hazards involved. Children shall not play with the
appliance. Cleaning and user maintenanceshall not be made by children without
supervision.
The batteries in remote controller must be recycled or disposed of properly. Disposal of
Scrap Batteries --- Please discard the batteries as sorted municipal waste at the
accessible collection point.
If the appliance is fixed wiring, the appliance must be fitted with means for
disconnection from the supply mains having a contact separation in all poles that
provide full disconnection under overvoltage category III conditions, and these means
must be incorporated in the fixed wiring in accordance with the wiring rules.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a hazard.
The appliance shall be installed in accordance with national wiring regulations.
The air conditioner must be installed by professional or qualified persons.
The appliance shall not be installed in the laundry.
1