I/P Mode - Sony LMD-2451W Operating Instructions Manual

BLUE ONLY
Press the button to eliminate the red and green signals.
Only blue signal is displayed as an apparent
monochrome picture on the screen. This facilitates
"chroma" and "phase" adjustments and observation of
VCR noise.
MONO
Press the button to display a monochrome picture. When
the buttons is pressed again, the monitor switches
automatically to color mode.
MARKER
Press the button to display the marker. Set the aspect
marker and safety area size in the MARKER SETTING
menu (see page 27).
H/V DELAY
Press the button to observe the horizontal and vertical
sync signals at the same time.
MULTI DISPLAY
Press the button to display the multi display. Set the
multi display setting in the MULTI DISPLAY
SETTING menu (see page 28).
CLOSED CAPTION
Press the button to display the closed caption. Set the
closed caption setting in the CLOSED CAPTION
SETTING menu (see page 30).
Not available for the signal input from BKM-227W.
APA (Auto Pixel Alignment)
Press the button to adjust the picture automatically to
maximum clarity for the signal input to the HD15 input
connector. For finer according to the input signal, see
"DOT PHASE" on page 25.
When the menu screen is displayed, the APA does not
function.
Note
If the APA operation does not finish correctly depending
on the input signal, adjust DOT PHASE (page 25).

I/P MODE

Press the button to set the delay by the picture
processing to the minimum level when interlace signal
is input. The mode switches in the sequence INTER-
FIELD t FIELD MERGE t LINE DOUBLER with
every press of the button (see "I/P MODE" on page 26).
30
Adjustment Using the Menus
CLOSED CAPTION SETTING
For the composite or Y/C input
USER CONFIG – CLOSED CAPTION SETTING
C L O S E D C A P T I O N E N A B L E :
C A P T I O N V I S I O N :
Submenu Setting
CLOSED Select ON to display closed caption and
CAPTION OFF not to display.
ENABLE
Note
When you display closed caption, set
FORMAT DISPLAY (page 26) to OFF
or AUTO, and set MARKER ENABLE
(page 27) and MULTI DISPLAY
ENABLE (page 28) to OFF.
CAPTION VISION Sets closed caption.
You can select from among OFF, CC1,
CC2, CC3, CC4, TEXT1 and TEXT2.
For a signal input from a BKM-244CC
(when a BKM-244CC is installed)
USER CONFIG – CLOSED CAPTION SETTING
C L O S E D C A P T I O N E N A B L E :
B K M - 2 4 4 C C
T Y P E :
7 0 8 :
6 0 8 :
C A P T I O N L E V E L :
Submenu Setting
CLOSED Select ON to display closed caption and
CAPTION OFF not to display.
ENABLE
xxx
xxx
xxx
xxx
xxx
xxx
x