Other Programming; Changing The Handset Name - Panasonic KX-TGF350 Operating Instructions Manual

5
MMENUN a MbN: "Edit" a MSELECTN
6
Edit the name if necessary. a MOKN
7
Edit the phone number if necessary. a MOKN
a MSELECTN
Erasing an outside monitoring number
Handset
1
Press MMENUN on the handset being
monitored.
2
MbN: "On/Off" a MSELECTN
3
MbN: "On" a MSELECTN
4
MbN: Select the outside line. a MEDITN
5
MMENUN a MbN: "Erase" a MSELECTN
6
MbN: "Yes" a MSELECTN a MOFFN
Baby monitor sensitivity
You can adjust the sensitivity of the baby monitor.
Increase or decrease the sensitivity to adjust the
sound level needed to trigger the baby monitor
feature.
R This feature cannot be set during a monitoring
call.
Handset
1
Press MMENUN on the handset being
monitored.
2
MbN: "Sensitivity level" a MSELECTN
3
MbN: Select the desired setting. a MSAVEN
a MOFFN
Answering the baby monitor
n When monitoring with a unit:
Handset: Press M
Base unit: Press MZN to answer a call.
If you want to respond from the monitoring unit,
press MMUTEN.
R The monitoring unit will answer calls
automatically when the auto intercom feature
is set to "On" (page 18).
Note:
R If you receive an outside call when
communicating with the monitored handset,
the interrupt tone sounds.
– To answer the call with the handset, press
MOFFN, then press M
– To answer the call with the base unit, press
*1
MZN 3 times.
For assistance, please visit www.panasonic.com/support
TGF35x(en)_1205_ver041.pdf 35
N to answer a call.
N.
*1 If MMUTEN is pressed, press MZN 2 times.
n When monitoring from an outside line:
Answer the call.
If you want to respond from your monitoring
phone, press #1 using tone dialing.
You can turn off the baby monitor feature by
pressing #0.
Note:
R The unit disconnects the call automatically
after 2 minutes.

Other programming

Changing the handset name

The default handset name is "Handset 1" to
"Handset 6". You can customize the name of
each handset ("Bob", "Kitchen", etc.). This is useful
when you make intercom calls between handsets.
To display the handset name in standby mode,
turn on the handset name display feature
(page 35).
Handset
1
MMENUN#104
2
Enter the desired name (max. 10 characters).
3
MSAVEN a MOFFN
Displaying the handset name
You can select whether or not the handset name
is displayed in standby mode. The default setting
is "Off".
Handset
1
MMENUN#105
2
MbN: Select the desired setting. a MSAVEN
a MOFFN
2014/12/05
Programming
35
21:38:32