Call Block; Using The Mcall Blockn Button; Storing Unwanted Callers - Panasonic KX-TGF350 Operating Instructions Manual

Using the MCALL BLOCKN
button
You can press the MCALL BLOCKN button in the
following situations to disconnect the current call
and add a phone number to the call block list:
– when an incoming call is being received
– when an incoming call is being recorded by the
answering system
– when talking on an outside call
Once a phone number has been added to the call
block list, the unit will block calls from that phone
number in the future.
Handset / Base unit
1
Press MCALL BLOCKN under the situations
shown above.
2
Confirm the call block number and press
MYESN.
R The call block number is stored in the call
block list, "Caller blocked" is displayed,
and then the call is disconnected.
Note:
R If the call has no phone number, the call is
blocked but it is not stored in the call block list.
R The call block feature is not available for
intercom calls or calls received by call waiting.
R Blocked calls are logged in the caller list.

Storing unwanted callers

The unit can block calls by storing the desired
items in the call block list beforehand (Caller ID
subscribers only).
– "Block a single number": The unit blocks
calls from specific phone numbers stored in the
call block list.
– "Block range of numbers": The unit
blocks calls that begin with a number stored in
the call block list, such as a toll-free phone
number prefix or certain area codes.
– "Block unknown CID": The unit blocks calls
that have no phone number.
Single phone numbers and ranges of numbers can
be stored in the call block list up to 250 items in
total.
Blocking unwanted callers:
When a call is received, the unit rings briefly
while caller information is being received.
For assistance, please visit www.panasonic.com/support
TGF35x(en)_1205_ver041.pdf 19
If the caller's phone number matches an entry in
the call block list, the unit emits no sound to the
caller, and disconnects the call.
*1 If you do not want this one ring to sound,
select "No" in "Setting not to ring once for
blocked call" (page 20).
Storing a single phone number
Important:
R We recommend storing 10 digits (including the
area code). If only 7 digits are stored, all
numbers that have the same last 7 digits will be
blocked.
Adding call blocked numbers from the caller
list
Handset
1
MCN CID
2
MbN: Select the entry to be blocked.
R To edit the number: MMENUN a MbN:
"Edit" a MSELECTN
Press MEDITN repeatedly until the phone
number is shown in the 10-digit format. a
MSAVEN a MbN: "Call block" a
MSELECTN a Go to step 4.
3
MCALL BLOCKN
4
MbN: "Yes" a MSELECTN
5
Edit the phone number if necessary (24 digits
max.).
6
MSAVEN a MOFFN
Base unit
1
MCIDN
2
MbN: Select the entry to be blocked.
R To edit the number: Press MEDITN
repeatedly until the phone number is shown
in the 10-digit format.
3
MCALL BLOCKN
4
MbN: "Yes" a MSELECTN
5
Edit the phone number if necessary (24 digits
max.).
6
MSAVEN a MEXITN
Adding call blocked numbers manually
Handset
*1 1
MCALL BLOCKN

Call Block

19
2014/12/05 21:38:30