Troubleshooting; General Information - Philips Crystal 660 Installation Manuallines

Networking basics network installation guidelines

Hide thumbs Also See for Crystal 660:

5. Troubleshooting

5.1.1 Print Network Report

A summary of the network settings can be printed out with the help of Menu 9,5. On this

reports the user can find out which networking components are enabled and which networking

modes are set.

5.1.2 Restore factory default WLAN settings

If it is necessary to restore the default settings of the wireless network configuration, the user

can do so by using the Menu 9,1,9.

5.2 Changing the printer's IP address

If you change the IP address of your Crystal printer, the device will shutdown the network

adapter and restart it with the new network parameters. Therefore the connection will be lost

for about five to ten seconds. After this period you should be able to access the printer again

with a ping command.

To make sure that the new IP address is set in the device one has to exit the wireless LAN

menu. This initiates the reboot of the WLAN USB adapter.

The second step is getting the PC network printer driver to communicate again with the

Crystal printer. To achieve open the Windows printer menu START > Settings > Printers.

Select your network printer and right-click on it. Choose the properties menu and in there

choose the Ports tab. Normally the Crystal Network Port should be selected, if not select it

now and click on the Configure Port button.

Table of Contents