Print Settings - Canon MG6800 Series Online Manual

Hide thumbs Also See for MG6800 Series:

Table of Contents

Print settings

• Prevent paper abrasion

Use this setting only if the print surface becomes smudged.

• Be sure to set this back to OFF after printing since it may result in lower printing speed or lower

print quality.

• Extended copy amount

Selects the amount of image that extends off the paper when printing in borderless (full).

Slight cropping may occur at the edges since the copied image is enlarged to fill the whole page. You

can change the width to be cropped from the borders of the original image as needed.

• This setting can be applied under the following conditions:

- Performing borderless copying

- Borderless is selected for Border when copying printed photos

• If printouts contain margins even though you are printing in Borderless, specifying Extended

amount: Large for this setting may help solve the problem.

• Auto photo fix setting

When ON is selected, you can select whether to print photos using the Exif information recorded in the

image files in the following cases.

◦ Auto photo fix is selected for Photo fix when printing from a memory card.

◦ The print setting on the PictBridge (Wireless LAN) compliant device is set to Default* or On when

printing with a PictBridge (Wireless LAN) compliant device.

* When Default is selected for the print setting on the PictBridge (Wireless LAN) compliant device,

select Auto photo fix for Photo fix in PictBridge print settings.

• Prevent paper double-feed

Select ON to prevent double-feed of plain paper.

• Select ON only when double-feed of plain paper occurs.

• Adjust horizontal print position

Adjusts the print position when the left/right margins are not aligned.

You can adjust the left/right margins in increments of 0.003 inches/0.1 mm between -0.1 inches/-3 mm

and +0.1 inches/+3 mm centered on the horizontal center of the paper.

• For Letter-sized or Legal-sized paper, you can adjust the left/right margins between -0.05

inches/-1.5 mm and +0.05 inches/+1.5 mm even if you specify the value over 0.05 inches/1.5 mm.

Show Quick Links

Table of Contents