Turning Off Your Vivomini; Putting Your Vivomini To Sleep; Entering The Bios Setup; Quickly Enter The Bios - Asus VivoMini UN Series User Manual

Turning off your VivoMini

If your VivoMini is unresponsive, press and hold the power button
for at least four (4) seconds until your VivoMini turns off.

Putting your VivoMini to sleep

To put your VivoMini on Sleep mode, press the Power button once.

Entering the BIOS Setup

BIOS (Basic Input and Output System) stores system hardware
settings that are needed for system startup in the VivoMini.
In normal circumstances, the default BIOS settings apply to most
conditions to ensure optimal performance. Do not change the
default BIOS settings except in the following circumstances:
• An error message appears on the screen during the system
bootup and requests you to run the BIOS Setup.
• You have installed a new system component that requires further
BIOS settings or update.
WARNING! Inappropriate BIOS settings may result to instability
or boot failure. We strongly recommend that you change the BIOS
settings only with the help of a trained service personnel.

Quickly enter the BIOS

To quickly enter the BIOS:
• Press the power button for at least four (4) seconds to shut down
your VivoMini, then press the power button again to turn your
VivoMini back on, then press <F2> or <Del> during POST.
• When your VivoMini is off, disconnect the power cord from your
VivoMini's power connector. Reconnect the power cable and
press the power button to turn on your VivoMini. Press <F2> or
<Del> during POST.
NOTE: POST (Power-On Self Test) is a series of software controlled
diagnostic tests that run when you turn on your PC.