Touchpad Button Board - HP ENVY m7 Maintenance And Service Manual

TouchPad button board

Description
NOTE: Some models have the touchpad button board spared with the top cover. Removal is only
required on select models.
TouchPad button board (includes cable) for use with HP ENVY 15 Notebook PC computer models
TouchPad button board (includes cable) for use with HP ENVY 17 Notebook PC computer models
Before removing the TouchPad button board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the optical drive (see
6. Remove the top cover from the base enclosure (see
Remove the TouchPad button board:
1. Turn the top cover upside down, with the front toward you.
2. Remove the two broadhead screws (1) that secure the TouchPad button board bracket to the top cover.
NOTE:
3. Remove the TouchPad board by carefully pushing the TouchPad down (2) and routing the cable through
the opening (3) (the cable was disconnected earlier from the top cover).
Reverse this procedure to install the TouchPad button board.
Battery on page
Optical drive on page
Some models may have three broadhead screws for the TouchPad button board (1).
37).
38).
Base enclosure on page
Component replacement procedures
Spare part number
763790-001
763712-001
41).
57