Assigning Functions To The Assign Buttons - Sony F65 Operation Manual

Settings page 2
Time code display types
Indication Meaning
TCG 00:00:00:00 Time code generator's time code data.
DF or NDF is displayed, depending on
the time code type.
TCR 00:00:00:00 LTC or VITC reader time code data. LTC
or VITC is displayed on the right. Also,
DF or NDF is displayed, depending on
the time code type.
UBG 00 00 00 00 Time code generator's user bit data.
UBR 00 00 00 00 LTC or VITC reader user bit data. LTC or
VITC is displayed on the right.
TM1 00:00:00:00 Timer1 timer value.
TM2 00:00:00:00 Timer2 timer value.
3-3-13 Assigning Functions to the
ASSIGN Buttons
Separate functions can be assigned to each of the ASSIGN
buttons 1 to 4 on the side of the camera body.
The following functions are assigned to the buttons by
factory default.
Button Function
ASSIGN 1 Mag
ASSIGN 2 Mag Position
ASSIGN 3 Hi/Lo Key
ASSIGN 4 Rec Review
Functions that can be allocated to the ASSIGN
buttons
Menu indication Function
OFF No function is allocated.
Mag Displays a magnified image in the
viewfinder and on the SDI OUT
connectors.
Each time the button is pressed, the
magnification changes between 2-
times, 4-times, and Off. When the
magnification is 2-times or 4-times, the
ASSIGN button allocated with the Mag
function is lit.
The display returns to normal after
about 30 seconds.
32
Basic Settings using the Subdisplay
Timecode
Menu indication Function
Mag Position Selects the position of the image that
is magnified by the Mag function.
There are nine points on the screen
that can act as the center point of the
magnified image. This function sets the
position of the magnified image as an
area centered on one of these points.
Each time the button is pressed, the
area moves one position from top left
to bottom right. When the display is
magnified, the ASSIGN button
allocated with the Mag Position
function is lit.
Hi/Lo Key Temporarily changes LUT for checking
the high-luminance brightness and
low-luminance darkness of the image
in the viewfinder and from the SDI
OUT connectors.
Areas blown-out are displayed in red
in Hi Key mode by setting Highlight
Clip Indicator to On.
The button toggles between high-
luminance check (gain reduction), low-
luminance check (gain amplification),
and normal.
The display returns to normal after
about 30 seconds.
Fan Mode Switches the fan operating mode.
For details on the fan operating mode,
see "3-3-9 Selecting the Fan
Operating Mode" (page 30).
Rec Review Plays the video just recorded.
The playback interval (all or the last
five seconds) follows the setting in the
SR-R4 menu.
Bars Outputs color bars.
Can be assigned to ASSIGN 4 only.
1
Select AS1 to AS4 for the button you wish to assign on
settings page 3, then press the MENU SEL/ENTER dial.
Settings page 3
ASSIGN buttons
2
Turn the MENU SEL/ENTER dial to select the
function to assign, then press the MENU SEL/ENTER
dial.