Black & Decker GST2000 Original Instructions Manual page 8

ENGLISH
Accessories
1. The Lint pad (17) and Brush (18) can be
fitted by simply clipping them on steam
head.
2. The pleat maker (16) can be fitted by
sliding the pivoting clip on the pleast
maker into the receptical on the steam
head.
3. The ironing support (19) can be fitted by
removing the clothes hanger and sliding
the ironing support over the top portion
of the telescopic poles then refitting the
clothes hanger.
4. The Shaper accessory for steaming
collars (21) can be used to support the
collar of a garment whilst steaming.
8
Use
Warning: Whever using this appliance,
always wear the heat resistant glove (20) on
the hand that is not holding the steam head.
1. Lift the water tank from the unit.
2. Turn the tank upside down then remove
the filler cap (22) by turning it
anti-clockwise.
3. Hold the tank under cold running water
and fill to the desired level.
Note: Only fill the water tank with cold
water, DO NOT use hot water, DO NOT add
perfume, vinegar starch, descaling agents,
ironing aids or other chemicals to avoid
damage to your steamer.
4. When you have finished filling the tank
screw the filler cap back on by turning it
clockwise.
5. Place water tank back into unit and make
sure it is securely seated in the cavity.
6. Plug the steamer cord into the electrical
outlet. (A beep will be heard)