Makita LS1016 Instruction Manual page 22

009511
Turn the hex socket bolt on the right side of
the arm holder two or three revolutions
counterclockwise to tilt the blade to the right.
1
001819
Carefully square the side of the blade with the
top surface of the turn base using the
triangular rule, try-square, etc. by turning the
hex socket bolt on the right side of the arm
holder clockwise. Then tighten the lever
securely.
1
2
009490
Make sure that the pointers on the arm holder
point to 0° on the bevel scale plate on the arm.
If they do not point to 0°, loosen the screws
which secure the pointers and adjust them so
that they will point to 0°.
(2) 45° bevel angle
1
2
4
3
009608
1. 0 ﾟ Angle
adjusting bolt
3
2. Lever
3. Latch lever
2
1
1. Triangular rule
2. Saw blade
3. Top surface of
2
turn table
3
1. Bevel scale
plate
2. Pointer
1. Pointer
2. Scale plate
3. Left 45 ﾟ bevel
angle adjusting
bolt
4. Right 45 ﾟ bevel
angle adjusting
bolt
Adjust the 45° bevel angle only after
performing 0° bevel angle adjustment. To
adjust left 45° bevel angle, loosen the lever
and tilt the blade to the left fully. Make sure
that the pointer on the arm holder points to
45° on the bevel scale on the arm. If the
pointer does not point to 45°, turn the left 45°
bevel angle adjusting bolt on the side of the
arm until the pointer points to 45°.
To adjust right 45° bevel angle, perform the
same procedure described above.
Adjustment of the laser line position
For models LS1016L and LS1016FL only
1
009526
1
009527
WARNING:
Since the tool must be plugged in while
•
adjusting the laser line, special care must be
taken to not switch on the tool. Accidental start
up of the tool may result in serious personal injury.
CAUTION:
Never look directly into the laser beam. Direct
•
eye exposure to the beam could cause serious
damage to the eyes.
LASER RADIATION
•
Do not stare into beam.
NOTICE:
Beware that impacts to the tool may cause the laser
•
line to be misaligned or may cause damage to the
laser, shortening its life.
22
1. Workpiece
2. Laser line
2
1. Vertical vise