Maintenance & Care; Empty Dirty Water Tank - Bissell PROHEAT 2X REVOLUTION 1548 Series User Manual

Maintenance:
WARNING
To reduce the risk of fire, electric shock or injury, turn power OFF and disconnect plug from
electrical outlet before performing maintenance or troubleshooting.
1
To release dirty water
tank, press down on the
colored tank handle.
4
www.BISSELL.com
14

Empty Dirty Water Tank

2
Tilt the tank slightly toward
you. Grab the handle and
tank with both hands.
For quick empty:
Pull the rubber tab
and tilt to pour.
(Located at the corner
of the top of the tank.)
When closing the
rubber tab, make
sure all edges are
sealed tight.
For final clean and
rinse: Unscrew the ring
at the bottom of tank.
Gently remove the
float stack, rinse,
and clean.
Once clean, return float
stack into the tank by
lining up the arrows
so they point at each
other. This is the only
way the float stack will
fit into the tank.
With the arrows
aligned, the float stack
should lock into place.
Return the ring and
twist to lock. Water
may leak if the ring is
not fully tightened.
3
Pull dirty water tank up
and away to remove.
5
Clean the red filter
below the dirty
tank by wiping off
any remaining dirt
or debris.
6
To return the dirty
tank: Angle the tank
and insert bottom
first. Then tilt the
tank toward the
machine and push
the top in until it
clicks into place.
Did You Know?
The Float Stack
is what prevents
your dirty
tank from
overflowing.