Recording - Williams ALLEGRO 2 Owner's Manual

ALLEG R O 2 D I G ITAL P IAN O

RECORDING

Recording Your Own Song
1. Press the Song and Play buttons
simultaneously.
2. Once you start playing, the button LEDs
will flash to indicate that the recording
has started.
3. When you finish playing, press the SONG and
PLAY buttons again to stop the recorder, or
you can press PLAY only to stop the recorder
and hear your song.
Layer Mode
To layer two sounds, press the corresponding
voices simultaneously. Both voice LEDs will
light up to indicate that they are layers.
To layer two sounds in different banks, press
and hold simultaneously the instrument in the
first bank and the bank button. The bank button
LED will blink and the first instrument button
will be lit. Once the bank button is blinking,
select the layered instrument from the second
bank by pressing the corresponding Instrument
button. Once selected, this button will blink to
indicate that it is from the second bank while
the instrument from the first bank stays lit. If
two voices are in the first and second bank (but
on the same button) are selected, the buttons
should merely blink.
To return to normal, single voice mode, press a
single Voice button.
To Change The Layer Volume Level
1. Press the Function button.
2. Turn the Value Dial to select the Layer
Volume Level edit menu, the display will
show "D .Volume".
3. Press the Function button again to enter
parameter edit menu. The numeric parameter
will blink to indicate the number is editable.
W ILLIAM S P IAN OS. CO M
4. Turn the Value Dial to select the level of the
layer volume (0-127).
D.Volume
SPLIT MODE
Split Mode allows the keyboard to be divided
into two sections so that different voices may
be played with the left and right hands. The
volume may be independently adjusted for each
voice, the Split Point (the highest note played
with the left hand) may be adjusted and the
Split Voice may be changed as desired.
To Enter Split Mode
Press the [SPLIT] button.
The Split (left hand) voice will be the last Split
Voice used and the Split Point will be B2.
To Change The Split Volume (Upper And
Lower)
1. Press the Function button.
2. Turn the Value Dial to select the Split Volume
Level edit menu, the display will show
"S .Volume".
3. Press the Function button again to enter the
parameter edit menu. The numeric parameter
will blink to indicate the number is editable.
4. Turn the Value Dial to select the level of the
split volume (0-127).
S.Volume
11