ASSEMBLING AND ADJUSTMENTS
Safety when assembling and
settings
WARNING! The engine emits carbon
!
monoxide, which is a colourless, poisonous
gas. Do not use the machine in enclosed
spaces.
•
Never leave the machine unsupervised with the motor
running.
•
Never allow children or other persons not trained in the
use of the machine to use or service it. Local laws may
regulate the age of the user.
•
Electrical shocks can cause injuries. Do not touch cables
when the engine is running. Do not test the ignition
system with your fingers.
WARNING! The engine and the exhaust
!
system become very hot during operation.
Risk of burn injuries if touched.
•
The machine is tested and approved only with the
equipment originally provided or recommended by the
manufacturer.
Cutting unit
Rider 213 C is equipped with a 3-blade Combi-deck.
•
Combi 94
Rider 216 and 216 AWD can be equipped with two different
cutting units.
•
Combi 94
•
Combi 103
The Combi-unit, equipped with a BioClip-plug, finely chops
the cuttings to fertiliser. Without the BioClip-plug the unit
works in the same way as a rear ejection unit.
Removing the cutting unit
WARNING! Wear protective glasses when
!
dismantling the cutting unit. The spring
which tensions up the belt may break and
cause personal injury.
1 Place the machine on a flat surface and apply the parking
brake. Set the cutting height control in the lowest position
and lift up the cutting unit.
2 Release the clip on the front hood and lift off the fender.
3 Loosen on the cutting height stay and place in the holder.
4 Loosen the spring on the drive belt's belt idler by pulling
the spring eye.
5 Place the spring eye in the holder.
6 Lift off the drive belt and hang on the load-relieving hook.
– 11
English