Safety Considerations - JL Audio MHD600/4-24V Owner's Manual

cooling efficiency considerations:
The outer shell of your JL Audio amplifier
is designed to remove heat from the amplifier
circuitry. For optimum cooling performance,
this outer shell should be exposed to as large a
volume of air as possible. Enclosing the amplifier
in a small, poorly ventilated chamber can
lead to excessive heat build-up and degraded
performance. If an installation calls for an
enclosure around the amplifier, we recommend
that this enclosure be ventilated with the aid
of a fan. In normal applications, fan-cooling
is not necessary.
Mounting the amplifier upside down is
strongly discouraged.
If mounting the amplifier under a seat,
make sure there is at least 1 inch (2.5 cm) of
space above the amplifier's outer shell to permit
proper cooling.
e Preouts From Input Sensitivity
Selection
(pg. 13)
Remote Level
Control Input Voltage
Selection Selection
(pg. 13) (pg. 10)
Front
Speaker Outputs Speaker Outputs
(pgs. 14-15) (pgs. 14-15)
Filter Slope
Control Selection
(pg. 10) (pg. 11)
Filter Mode
Filter Frequency
Selector
(pg. 11)
Rear

safety considerations:

Your amplifier needs to be installed in a dry,
well-ventilated environment and in a manner
which does not interfere with your vessel's factory
installed electronic devices. You should also take
the time to securely mount the amplifier so that
it does not come loose in the event of a collision/
sudden jolt or as a result of the repeated vibrations
the vessel is prone to during normal operation.
stupid mistakes to avoid:
• Check before drilling any holes in your vessel to
make sure that you will not be drilling through
the hull, a fuel tank, fuel line, wiring harness or
other vital vessel system.
• Do not run system wiring outside or underneath
the vessel. This is an extremely dangerous
practice which can result in severe damage to
your vessel and person.
• Protect all system wires from sharp edges
(metal, fiberglass, etc.) by carefully routing
them, tying them down and using grommets
and loom where appropriate.
• Do not mount the amplifier in the engine
compartment or in any other area that will
expose the amplifier circuitry to the elements.
Selection
(pg. 11)
While this amplifier is specially designed
for marine applications, it is not waterproof
and it should not be mounted where it is
likely to get wet.
3