Installing Door Handle - Electrolux A01061201 Use And Care Manual

Door Handle
Mounting Instructions
1. Remove handle from carton and any
other protective packaging.
2. Position refrigerator handle end caps
over upper and lower pre-installed
shoulder bolts (A) that are fastened
into door, ensuring the holes for
the set screws are facing towards
the outside of door if a single unit
installation or the freezer door (if
installing the matching freezer)
3. While holding handle firmly against
door, fasten upper and lower Allen set
screws (B) with supplied Allen wrench.
4. Repeat steps 2 and 3 to install
freezer handle (if installing the
matching freezer). Ensure the holes
for the set screws are facing towards
the freezer door.
NOTE
All set screws should be tightened and
sub-flush (Allen set screw should be seated
just below the surface of the end cap) of
handle end cap. The end caps should be
drawn tight to door with no gaps.
Toe Grille Removal
To remove the toe grille, use a Phillips
head screwdriver and remove the two
screws holding the toe grille to the cabinet.
Then pull the toe grille away from the unit.
Leveling
• The refrigerator must have all bottom
corners resting firmly on a solid floor.
• The floor must be strong enough to
support a fully loaded refrigerator.
• It is VERY IMPORTANT for your
refrigerator to be level in order to
function properly. If the refrigerator
is not leveled during installation,
the door may be misaligned and
not close or seal properly, causing
cooling, frost or moisture problems.

Installing Door Handle

A
B
Single Unit Installation
Ensure handle set screws
are facing each other
Matching Refrigerator and Freezer Door
Handle Installation
with doors closed
Toe Grille
Remove
Screws
7