Removing The Appliance - Siemens SF 65T350 Instructions For Use Manual

Hide thumbs

Advertisement

Table of Contents
en

Removing the appliance

It is essential, when removing the
appliance, to observe the following
sequence: First, disconnect the appliance
from the power supply.
Pull out the mains plug.
Turn off the water supply.
Disconnect the waste water and fresh
water connections.
Loosen the fastening screws under the
worktop. If fitted, remove the base panel.
Pull out the appliance, carefully pulling the
hose behind.
Transporting the dishwasher
Drain water from the dishwasher. Secure
all loose parts. The appliance should only
be transported in an upright position.
If the appliance is not kept upright
during transport, any water left inside
may seep into the control module and
cause subsequent errors with
programme functions.
The appliance must be drained in the
following sequence:
Turn on the tap.
Set main switch to ON.
Select the B programme. The
programme duration in minutes is
shown in the numerical display.
Close the door.
Wait for approximately 4 minutes.
Terminate the programme by
pressing A and C
simultaneously.
The time display changes to
Wait a further minute and then
switch the appliance off.
Turn off the tap.
28
Downloaded from DishWasher-Manual.com Manuals
Protection from freezing
temperatures
If the appliance is installed in a location
where there is a risk of freezing
temperatures (e.g. in a holiday home), all
water must be completely drained out of
the interior (see "Transporting the
dishwasher").
Turn OFF the tap, disconnect the supply
hose and allow to drain.
.

Advertisement

Table of Contents
loading