Inspection And Repairs; Electrical Safety; After Use - Black & Decker JIS300 Original Instructions Manual

ENGLISH

After use

• Remove the plug from the socket before
leaving the appliance unattended and
before changing, cleaning or inspecting
any parts of the appliance.
• When not in use, the appliance should be
stored in a dry place. Children should not
have access to stored appliances.

Inspection and repairs

• Before use, check the appliance for
damaged or defective parts. Check for
breakage of parts, damage to switches
and any other conditions that may a ect
its operation.
• Switch off the appliance and disconnect
from supply before changing accessories
or approaching parts that move in use.
• Do not use the appliance if any part is
damaged or defective.
• Do not use the appliance if the rotary
sieve is damaged.
• Have any damaged or defective parts
repaired or replaced by an authorised
repair agent.
• Before use, check the power supply cord
for signs of damage, ageing and wear.
• Do not use the appliance if the power
supply cord or mains plug is damaged or
defective.
• If the power supply cord or mains plug is
damaged or defective it must be
repaired by an authorised repair agent in
order to avoid a hazard. Do not cut the
power supply cord and do not attempt
to repair it yourself.
4
• Never attempt to remove or replace any
parts other than those specified in this
manual.

Electrical safety

Before use, check that the mains voltage
corresponds to the voltage on the rating
plate.
This appliance is double insulated
in accordance with
EN 60335-2-14; therefore no earth
wire is required
• To avoid the risk of electric shock, do not
immerse the cord, plug or motor unit in
water or other liquid.
• Check that the supply voltage shown on
the rating plate of the appliance matches
that of your electrical system. Any
connection error will invalidate the
guarantee.
Labels on appliance
The following warning symbols are found on
the appliance:
Warning! Allow moving parts to
come to a stop before
approaching.
Assembly
1. Wash all detachable parts (see chapter
'Maintenance and cleaning').
2. Place the pulp container (E) onto the
appliance.
3. Place the juice collector (D) onto the
appliance.
4. Put the rotary sieve (C) in the juice
collector and lower it into position. Make
sure the rotary sieve is fitted securely
onto the driving shaft ('click').