Troubleshooting - Kenwood KM300 series Instructions Manual

troubleshooting

problem
l
The whisk or K-beater knocks against the bottom of the bowl or isn't
reaching the ingredients in the bottom of the bowl.
l
Adjust the height. Here's how:
solution
Unplug.
1
Raise the mixer head and insert the whisk or beater.
2
Hold it, then loosen the nut
3
Lower the mixer head.
4
Adjust the height by turning the shaft. Ideally the whisk/K-beater should
5
be almost touching the bottom of the bowl
Raise the head, hold the whisk/K-beater and tighten the nut.
6
to fit and use your splashguard (if
supplied)
Raise the mixer head until it locks.
1
Fit the bowl onto the base.
2
Push the splashguard onto the underside of the mixer head
3
located. The hinged section should be positioned as shown.
Insert required tool.
4
Lower the mixer head.
5
l
During mixing, ingredients can be added directly to the bowl via the hinged
section of the splashguard
l
You do not need to remove the splashguard to change tools.
Remove the splashguard by raising the mixer head and sliding it down.
6
.
5
until fully