List Of Messages - Canon Legria HF R47 Instruction Manual

- Remove any objects between the camcorder and wireless access point that may interfere
with the wireless signal.
- Move the camcorder closer to the wireless access point.
- Turn off the wireless functions of other wireless devices other than the computer or similar
device being used for playback.
- Switch the wireless access point to IEEE802.11n. Refer to its instruction manual for details.
- If these do not solve the issue, the cause may be due the device or conditions unique to the
surrounding area. Use the supplied High Speed HDMI cable to connect the camcorder to a TV
(A 103).
The wireless connection was interrupted while transferring files.
- Incomplete files may remain at the transfer destination. If incomplete files remain at the
transfer destination, check the content and make sure they are safe to delete before deleting
them.
- Select [New Files] and perform the file transfer again.
Cannot connect a Wi-Fi-enabled external device wirelessly to the camcorder.
- Use the q > [Reset All] setting to reset the camcorder. The camcorder's SSID will
return to the default setting and the password will change. Delete the previous network set-
tings from the external device and try to connect it to the camcorder.

List of Messages

:/9/8 Refer to List of Messages for Connecting to an
External Hard Drive (A 167) for messages related to an external hard
drive, List of Messages for Wi-Fi Functions (A 167) for a list of mes-
sages related to general Wi-Fi functions, and List of Messages for Web
Services (A 169) for messages related to Web services when using
Wi-Fi functions.
Back up recordings regularly
- This message may appear when you turn on the camcorder. In the event of a malfunction,
recordings may be lost so back up your recordings regularly.
:/9/8 Built-in memory error
- The built-in memory could not be read. Contact a Canon Service Center.
:/9/8 Built-in memory is full
- The built-in memory is full ([& End] appears on the screen). Delete some recordings
(A 55, 57) to free some space. Alternatively, save your recordings (A 108) and initialize
the built-in memory (A 31).
:/9/8 Built-in memory writing error Attempt to recover the data?
- This message will appear the next time you turn on the camcorder if power supply was acci-
dentally interrupted while the camcorder was writing to the built-in memory. Select [Recover]
to try to recover the recordings.
Downloaded From VideoCamera-Manual.com Manuals
(in alphabetical order)
Additional Information
161