Unpacking; Installation - LG LFX21960ST Training Manual

REFRIGERATOR

INSTALLATION

UNPACKING

Leave the refrigerator in its box and packaging until it is at the installation area.
Remove the box and any shipping tape and temporary labels. DO NOT
REMOVE the serial number label or any WARNING labels.
After cutting the straps, lift the box off over the top of the refrigerator. This is
usually easier outdoors, where there is sufficient vertical clearance.
To remove any tape residue, rub it with your finger. If that doesn't roll it up, rub it
with a couple of drops of dishwashing liquid and wipe it off with a damp towel.
DO NOT USE sharp instruments, rubbing alcohol, flammable liquids, solvents, or
abrasive cleaners.
The shelves are installed in the shipping position at the factory. After removing all
the cardboard and shipping materials, the customer can arrange the shelves
according to his personal preference.
INSTALLATION
While most kitchens have a place already designed for a refrigerator, we remind
you not to install the refrigerator near a heat source, a damp spot, or in bright
sunlight. The refrigerator is designed to be installed in an area where the ambient
temperature is between 55° F and 110° F (13° C and 43° C). If the ambient
temperature is outside this specification, the refrigerator's performance may be
affected adversely.
Connect the water line. (See page 15.) Turn on the water and check for leaks
before pushing the refrigerator into position.
To avoid vibration, the refrigerator must be level. After rolling the refrigerator into
position, lower the leveling legs to take the weight off the front wheels and level
the refrigerator.
Turn the feet with a screwdriver to raise
or lower the front of the refrigerator.
The large hole visible is for the type of
base grille that presses into place
instead of being attached with screws.
The feet are also used to align the
doors so they hang evenly.
(See next page.)
LFX21960ST/LFX25960xx Page 12 of 75 TRAINING MANUAL