• If there is value in the x cell above the currently highlighted x cell,
pressing or automatically inputs into the highlighted cell the
value equal to the value of the cell above it plus the step value. So also,
pressing automatically inputs the value equal to the value of the cell
above less the step value. The f(x) and g(x) values in the same line are
also updated accordingly.
• After pressing in step 4 above, proceeding from step 5 onwards
without inputting anything for g(x) will generate a number table for f(x)
• The maximum number of rows in the generated number table depends
on the setup menu table setting. Up to 45 rows are supported for the
"f(x)" setting, while 30 rows are supported for the "f(x),g(x)" setting.
• The number table generation operation causes the contents of variable x
to be changed.
Important: Functions input in this mode are deleted whenever the Input/
Output settings are changed in the Table Mode.
The calculator will display an error message whenever an error occurs for
any reason during a calculation. While an error message is displayed, press
or to return to the calculation screen. The cursor will be positioned
at the location where the error occurred, ready for input.
To clear the error message: While an error message is displayed, press
to return to the calculation screen. Note that this also clears the
calculation that contained the error.
• The intermediate or ﬁnal result of the calculation you are performing
exceeds the allowable calculation range.
• Your input exceeds the allowable input range (particularly when using
• The calculation you are performing contains an illegal mathematical
operation (such as division by zero).
→ Check the input values, reduce the number of digits, and try again.
→ When using independent memory or a variable as the argument of a
function, make sure that the memory or variable value is within the
allowable range for the function.
• The calculation you are performing has caused the capacity of the
numeric stack or the command stack to be exceeded.
→ Simplify the calculation expression so it does not exceed the capacity
of the stack.
→ Try splitting the calculation into two or more parts.
• There is a problem with the format of the calculation you are performing.
• There is a problem with the argument of the calculation you are
• An attempt to generate a number table in the Table Mode whose
conditions cause it to exceed the maximum number of allowable rows.