Kenwood FPP210 series Instructions Manual page 6

slicing/grating disc
l
Never remove the lid until the cutting disc has completely stopped.
l
Handle the cutting discs with care - they are extremely sharp
before plugging in
l
Make sure your electricity supply is the same as the one shown
on the underside of your appliance.
Important – UK only
l
The wires in the cord are coloured as follows:
Blue = Neutral, Brown = Live.
l
The appliance must be protected by a 13A approved (BS1362)
fuse.
Note:
l
For non-rewireable plugs the fuse cover MUST be refitted when
replacing the fuse. If the fuse cover is lost then the plug must not
be used until a replacement can be obtained. The correct fuse
cover is identified by colour and a replacement may be obtained
from your Kenwood Authorised Repairer (see Service).
l
If a non-rewireable plug is cut off it must be DESTROYED
IMMEDIATELY. An electric shock hazard may arise if an
unwanted non-rewireable plug is inadvertently inserted into a 13A
socket outlet.
l
This appliance conforms to EC directive 2004/108/EC on
Electromagnetic Compatibility and EC regulation no. 1935/2004
of 27/10/2004 on materials intended for contact with food.
before using for the first time
1 Remove the plastic blade covers from the knife blade. Take
care the blades are very sharp. These covers should be
discarded as they are to protect the blade during manufacture
and transit only.
2 Wash the parts see 'care & cleaning'
key
processor
pusher
feed tube
lid
detachable drive shaft
bowl with drive shaft
power unit
speed/pulse control
safety interlocks
cord storage (at back)
liquidiser
(if supplied)
blade unit
sealing ring
goblet
filler cap
lid
mini chopper/mill
jar
sealing ring
blade unit
(if supplied)
attachments
Not all of the attachments listed below may be included with your
food processor. Attachments are dependent upon the model
variant.
knife blade
dough tool (if supplied)
emulsifying tool
thick slicing/coarse grating disc
citrus juicer (if supplied)
spatula
recipe book (if supplied)
to use your food processor
1 Fit the bowl by aligning the
power unit, turn clockwise
2 Fit an attachment over the bowl drive
shaft.
Note: Detachable drive shaft
when using the disc or citrus juicer.
l
Always fit the bowl and attachment onto the processor before
adding ingredients.
3 Fit the lid - ensuring the top of the drive shaft/tool locates into
the centre of the lid.
l
Do not use the lid to operate the processor, always
use the on/off speed control.
4 Plug in, switch on and select a speed. (Refer to the
recommended speed chart).
l
The processor will not operate if the bowl or lid are
not fitted correctly into the interlock. Check that the
feed tube and bowl handle are situated to the right
hand side.
l
Use the pulse (P) for short bursts. The pulse will operate for as
long as the control is held in position.
5 Reverse the above procedure to remove the lid, attachments and
bowl.
l
lways switch off and unplug before removing the lid.
important
l
Your processor is not suitable for crushing or grinding coffee
beans, or converting granulated sugar to caster sugar.
l
When adding almond essence or flavouring to mixtures avoid
contact with the plastic as this may result in permanent marking.
4
on the bowl with the on the
until it locks .
should only be fitted