Download Print this page

Waste Water Pump; Troubleshooting - Siemens SN 56M531 Instructions For Use And Safety

Hide thumbs


Table of Contents

Waste water pump

Large food remnants in the rinsing water
not retained by the filters may block the
waste water pump. The rinsing water is
then not pumped out and covers the filter.
In this case:
First disconnect the appliance from the
power supply.
Remove the filters
Scoop out water, use a sponge
if required.
Using a spoon, prise off pump cover
(as illustrated) until it clicks, then grip
the cover by the lug and first pull it
upwards until it resists and then pull
it out forwards.
Check inner compartment and remove
any foreign objects.
Place cover in the original position,
press down and engage.
Install filters.
Downloaded from Manuals


Experience has shown that you can rectify
most faults which occur in daily operation
without calling customer service.
Obviously this will save on costs and
ensure that the machine is quickly
available again. The following overview
should help you locate the causes of faults
which may occur.
If fault code (E01 to E30) is indicated on
the digital display
appliance from the power supply.
You can rectify certain faults yourself
(see following fault description), for all
other faults please contact customer
service and state the indicated fault E:XX.
Remember: Repairs may be carried out by
technicians only. If a component has to be
replaced, ensure that only original spare
parts are used. Improper repairs or use
of non-original spare parts may cause
considerable damage and put the user
at considerable risk.
, first disconnect the


Table of Contents