Download Print this page

Remaining Running Time Display; Timer Programming; End Of Programme; Switching Off The Appliance - Siemens SN 56M531 Instructions For Use And Safety

Hide thumbs

Advertisement

Table of Contents
en

Remaining running time display

When the programme is selected, the
remaining running time of the programme
is indicated on the digital display
The running time is determined during the
programme by the water temperature, the
number of utensils as well as the degree
of soiling and may vary (depending on the
selected programme).

Timer programming *

* depending on model
You can delay the start of the programme
in 1-hour steps up to 24 hours.
Close the door.
Switch on ON/OFF switch
Press
+ button until the digital
4
display
jumps to
10
Press
+ or – button until the
4
displayed time corresponds with
your requirements.
Press START button
programming is activated.
To delete timer programming, press
the
+ or – button until
4
is indicated on the digital display.
You can change your programme
selection at any time until the
programme starts.

End of programme

The programme has ended when the
value
is indicated on the numerical
display
.
10

Switching off the appliance

Short time after the end of the programme:
Switch off ON/OFF switch
Turn off the tap (not applicable
if Aqua-Stop fitted).
Remove the utensils when they
have cooled down.
16
Downloaded from DishWasher-Manual.com Manuals
.
10
.
1
.
, timer
6
.
1
Warning
At the end of the programme please open
the door fully and not partially when
emptying the dishwasher. Any escaping
water vapour could damage sensitive
worktops.

Interrupting the programme

Switch off ON/OFF switch
The LEDs go out. The programme
is saved.
If the door was opened on an appliance
which has a warm water connection or
is heated, first leave the door ajar for
several minutes and then close.
Otherwise, expansion (pressure) may
cause the appliance door to spring
open or water to run out of the
appliance.
To continue the programme, switch on
the ON/OFF switch
Terminating the programme
(Reset)
Press START button
3 sec.
The numerical display
.
The programme sequence lasts
approx. 1 min.
On the digital display
.
Switch off ON/OFF switch
.
1
again.
1
for approx.
6
indicates
10
is indicated
10
.
1

Advertisement

Table of Contents
loading