Toshiba e-Studio 162 Service Manual page 90

Main Sub
Contents
code code
46 19 Exposure mode setting (AE
MODE)
20 ADF exposure correction
(EXP.LEVEL ADF)
(Disabled when set to OC)
(Executable only when the
ADF is installed.)
[Function]
γ
< table setting>
When this test command is executed, the code number of the current set gamma table is displayed.
(Default: US -1/Ex US -2)
Enter the code number corresponding to the desired gamma table, and press [
the mode and write into the EEPROM.
<AE operation mode>
γ
When setting the
number of the AE operation mode is displayed. (Default: 0)
Enter the code number corresponding to the desired AE operation mode and press [
change the mode and write into the EEPROM.
<PHOTO image process setting>
→
When [ ] key is pressed in AE operation mode setting, the mode is changed to the PHOTO image
process setting and the code number of the current set PHOTO image process setting is displayed.
(Default: 0)
Enter the code number corresponding to the desired PHOTO image process setting and press [
key to change the mode and write into the EEPROM.
Mode Display item
γ
GAMMA
AE AE
PHOTO PHOTO
[Operation]
1) Initial display
γ
< table setting>
46-19 AE MODE
GAMMA 2( 1-2)
[Function]
Used to adjust the exposure correction amount in the ADF mode. The adjustment is made by adjust-
ing Vref voltage variation for the OC mode.
When this test command is executed, the current set value is displayed in 2 digits (Default: 50).
Change the set value and press [START] key to save the setting and make a copy.
When the set value is increased, copy becomes darker. When the set value is decreased, copy
becomes lighter. (Adjustment range: 1 – 99)
Mode
ADF
[Operation]
The operation is similar to test command 46-01.
e-STUDIO162/162D/151/151D TEST COMMAND, TROUBLE CODES 10 - 21
Details of function/operation
→
table, press [ ] key to change to the AE operation mode, and the current set code
Code number
1 Image quality priority mode
2 Toner consumption priority mode
0 Lead edge stop
1 Real time process
1 Error diffusion process
2 Dither process
→
2) [ ] Mode selection
46-19 AE MODE
AE
←
2) [ ] Mode selection
46-19 AE MODE
PHOTO
Display item Default
ADF 50
←
/
Setting content
US default
EX US default
Default
Default
3) [10KEY] Value input
46-19 AE MODE
0( 0-1) AE
4) [OK (ENTER)/START]
Save the set value. The
machine goes to the sub
1( 1-2)
code entry standby mode.
Remark
→
] key to change
← →
/ ] key to
← →
/ ]
Remark
1( 0-1)