LG RC9055*P*Z Service Manual page 33

10
DIAGNOSTIC TEST
Test 10
Measurement condition : Check if they are working when connected to power supply.
Is the product leveled?
(Check shaking / tilt )
ta ~ ta~ ta~ sound)
※Check the status of the actions Sensor
- Drum Light + Buzzer 3 when entering
Pressing enter, Once again press the same key
fot three seconds to escape.
- Turn the Jog Dial in data view state data can be
checked as shown below.
- Not to enter the Child lock status.
- Apply the model : Only Touch LED model.
NO The course Show details
1 Refresh Humidity values
2 Skin Care Low Temp
3 Jeans Comp Temp
4 Bulky Item T_heater (High Thermistor)
5 Easy Care Eva in Temp
6 Mixed Fabric
7 Cotten
8 Sports Wear Sump Water Level
9 Quick Dry Drain Pump RPM
10 Delicate LEV Pulse
11 Wool Main PGM Tool
12 Rack Dry Main Version
Note: The roler noise (dung dung dung) at the initial operation, and pump and water flowing noise during auto cleaning
product. If noise of metal materials bumping each other occurs, check if screw is properly locked or if it is properly assembled.
Adjust product leveling
(Refer to how to leveling, Page 10)
2) After Comp on, check corresponding
thermistor temp.
Is Belt properly assembled to Pulley?
Is Journal Bearing grease properly
Sprayed?
( Refer to exploded view ,
Refer to picture C page35 )
Replace Journal bearing (D122)
Adjust pipe position to insure minimum
5mm gap with pipe or mold
Adjust pipe position to insure minimum
5mm gap with pipe or mold
Refer to picture A , page35
Replace real seal (D152)
33
Is the washer between Drum and
Rear cover flat?
( Refer to picture D , page35 )
TM are normal noises of the