Download  Print this page

Black & Decker BPSC1607 Original Instructions Manual page 8

Tilt saw
Hide thumbs

Advertisement

Table of Contents
ENGLISH
Adjustments. Before cutting be sure depth and bevel
adjustments are tight.
Support and secure the work properly. Insure that the
material to be cut is clamped (Fig. C) and solidly
supported and balanced on a strong, stable and level
work surface. Support the work so that the wide portion
of the saw shoe is on the portion of the material that
doesn't fall after the cut is made. Never hold cut off piece
by hand (Fig. D). KICKBACK from blade pinch can
result. Keep both hands on saw at all times.
Stay alert and exercise control. Keep body positioned
to one side of blade. Always maintain a firm grip and
control of saw with both hands. Do not change hand grip
or body position while saw is running. Take precaution to
avoid injury from cut off pieces and other falling material
during operation.
Danger! Release switch immediately if blade
binds or saw stalls.
Features (fig. e)
This tool includes some or all of the following features.
1. On/Off Switch
2. Main Handle
3. Secondary Handle
4. Shoe
5. Saw Blade
6. Saw Blade Guard
7. Blade Guard Retracting Lever
8. Saw Blade Spanner Wrench
9. Bevel Adjustment Knob
10. Outer Washer
11. Blade Retaining Screw Saw Blade Hex Wrench (Not
shown) Rip Fence (Shown on Fig. M)
8
Assembly/adjustment set-up
Warning! Always unplug saw from power supply
before any of the following operations.
Adjusting the Depth of Cut (Fig. F and G)
The depth of cut should be set according to the thickness of
the workpiece.
Loosen the lever (12) to unlock the saw shoe.
Move the saw shoe (4) into the desired position. The
corresponding depth of cut can be read from the scale
(13).
Tighten the lever to lock the saw shoe in place.
Set depth adjustment of saw such that one tooth of the
blade projects below the workpiece as shown in Fig. G.
Adjusting the Bevel Angle (Fig. H)
This tool can be set to bevel angles between 0° and 45°
Loosen the locking knob (9) to unlock the saw shoe.
Move the saw shoe (4) into the desired position. The
corresponding bevel angle can be read from the scale
(14).
Tighten the locking knob to lock the saw shoe in place.
Attaching the Blade (Fig. I and J)
To prevent spindle rotation engage the protrusions of the
spanner wrench (8) into the holes in the outer washer
(10) as shown in Fig. I.
Loosen and remove the blade retaining screw (11) by
turning the hex wrench (15) counter- clockwise.
Remove the outer washer.
Place the saw blade (5) onto the inner flange (16),
making sure that the arrow on the blade points in the
same direction as the arrow on the tool.

Advertisement

Table of Contents
loading

  Related Manuals for Black & Decker BPSC1607