Canon W2200 Service Manual page 42

Part 2 : Troubleshooting
3.4.5 NIC board's IP address settings
1) Make the printer offline and press the set up key to enter the set up menu.
2) When "Setup Menu / Ext. Features" is displayed, select "Set Interface" with
execute with
3) Select "Ext. Network" with
4) Select "Set TCP/IP" with
protocol and address.
5) For "Frame Type", select "Disable" or "Ethernet II" with
6) For "IP Mode", select "Automatic" or "Manual" with
7) Only when "Automatic" is selected for "IP Mode", it is necessary to set "Protocol".
7-1) Select "ON" or "OFF" for "DHCP" with
7-2) Select "ON" or "OFF" for "BOOTP" with
7-3) Select "ON" or "OFF" for "RARP" with
8) When "Manual" is selected for "IP Mode", it is necessary to set each of IP address, subnet
mask and gateway address.
8-1) Select "IP Setting".
As "IP Setting / IP Address ↓" will appear, execute with
8-2) Current IP address setting values will appear.
8-3) When
pressed, it moves to the left.
With
key or
8-4) Execute the remaining two settings similarly.
9) To register set values in the NIC board, press
↓" appears.
10) When "Regis. Settings / Execute?" appears, press
the NIC board.
11) When the printer receives setting registration completion notice from the NIC board,
"Regis. Settings / Registered!" appears on the display.
key.
key and enter the menu that is to set the frame type, IP mode,
For example, IP Address
=192.168.0.215
key is pressed, the under bar will move to the right, and when < key is
key, determine which under bar part to input, and select the values with
key. Confirm the selected value with
key and execute with
key and execute with
key and execute with
key and execute with
key when "Ext. Network / Regis. Settings
key and set values are registered in
2-24
key.
key and execute with
key and execute with
key.
key.
key.
key.
key.
W2200
key and
key.
key.