JVC KW-NT500HDT Instructions For Use Manual page 119

Symptoms
Total Traffic Network Service information
cannot be received from iHeartRadio.
"App Not Connected"
"Content Not Available"
"Request Timed Out"
"Stream Stopped"
Bluetooth device cannot be registered.
Echo or noise occurs.
Phone sound quality is poor.
The sound is interrupted or skipped while using
a Bluetooth audio player.
The connected audio player cannot be
controlled.
The unit does not responde when you tried to
copy the phone book to the unit.
"Memory full."
The rear view screen is not displayed when the
gear is shifted to the reverse (R) position.
Troubleshooting/error messages
Remedies/Causes
Confirm that the location services feature on the iPhone
or iPod touch is turned on.
• Next, confirm that location services for iHeartRadio is
turned on.
+
• Set Hybrid TTN Mode to any setting other than Off.
(☞ page 34)
Start iHeartRadio on the iPod touch or iPhone that is
connected to the navigation system.
Selected station is not being broadcast.
iPod touch or iPhone not connected. Confirm connection.
Data cannot be received from iHeartRadio server. Internet
connection is not good enough.
Enter the correct pass key or PIN code.
Adjust the microphone unit position.
• Reduce the distance between the unit and the
Bluetooth mobile phone.
• Move the car to the place where you can get a better
signal reception.
• Reduce the distance between the unit and the
Bluetooth audio player.
• Disconnect the device connected for Bluetooth phone.
• Turn off, then turn on the unit.
• (When the sound is not yet restored) connect the player
again.
Check whether the connected audio player supports
AVRCP (Audio Video Remote Control Profile).
You may have tried to copy the same entries (as stored)
to the unit.
You have tried to copy a 501st phone book entry. Delete
unwanted names before copying.
• Check <Camera Input> setting. (☞ page 84)
• Check the connection.
119