Notice; Tripod Mounting - Asante 8001/P/W User Manual

Asante user's manual network camera 8001/p/w

Hide thumbs Also See for 8001/P/W:

Table of Contents

The NetCam 8001 is supplied with a screw hole for tripod mounting. The screw hole is

located on the base of the unit, as shown below. The base plate of the NetCam 8001 is

similar, but is supplied with a ceiling or wall mounting plate instead of the tripod screw hole.

Wall Mounting the NetCam 8001

The NetCam 8001 is designed exclusively for ceiling/wall mounting and a special mounting plate is

supplied for the purpose. Screw the plate (screws not supplied) to the ceiling at the point of installation.

WARNING!

When installing the NetCam 8001 on the ceiling,

(1)

check the position of NetCam 8001 need to be vertically 90 degree even. Any non-vertical setting will cause

abnormal PAN/TILT operation.

(2)

check that the ceiling is strong enough to bear the weight of the camera plus the mounting plate. A weak fitting

could result in the camera falling and causing serious injury.

Please check for looseness in the camera installation mount at least once a year.

Please note that PAN degree -135° ~ 135°(Max120°/sec.) and Tilt degree -45° ~ 90° (Max120°/sec.).

Mounting Plate Information

3 Screw hole diameter: 6mm (1/4 in.)

Plate thickness: 1.6 mm (1/16 in.)

Note: The horizontal angle is important when you hang the product from the ceiling. Excessive

inclination may bring about abnormal rotation of the camera lens.

All other names may be trademarks or registered trademarks of their respective owners. Specifications subject to change without prior notice.

Ceiling Mounting the NetCam 8001

Table of Contents

Need help?

Do you have a question about the 8001/P/W and is the answer not in the manual?