Advertisement
MDX-G1
QQ
CONTENTS / ACCESSORIES / CAUTIONS
3 7 63 1515 0
Contents
CONTENTS / ACCESSORIES / CAUTIONS............. 2
CIRCUIT DESCRIPTION ............................................3
ADJUSTMENT ..........................................................11
WIRING DIAGRAM ...................................................12
PC BOARD .............................................................. 13
Accessories
Am loop antenna (1)
(T90-0865-05)
Cautions
TE
L 13942296513
Note related to transportation and movement
Before transporting or moving this unit, carry out the following operations.
(1) Remove the CD or MD from the unit.
(2) Press the 6 key of the MD.
(3) Wait for some time and verify that the display becomes as shown in the
figure.
(4) Press the 6 key of the CD.
(5) Wait for some time and verify that the display becomes as shown in the
figure.
(6) Wait a few seconds and turn the unit OFF.
The marking of products using lasers (Except for some areas)
LASER PRODUCT
The marking is located on the rear panel and says
www
this product has been classified as Class 1. It
means that there is no danger of hazardous radia-
tion outside the product
.
2
Batteries(R6/AA)
for remote (2)
SP
MD
CD
SP
CLASS 1
x
ao
y
i
8
SCHEMATIC DIAGRAM .......................................... 16
EXPLODED VIEW ....................................................26
PARTS LIST..............................................................28
SPECIFICATIONS ......................................Back cover
Remote control unit (1)
(A70-1509-05)
Battery cover (A09-1229-08)
Q Q
3
6 7
1 3
Operation to reset
The microcomputer may fall into malfunction when a cord is unplugged and
plugged again while the unit is ON or due to an external cause. In such a
case, the microcomputer should be reset as described below:
Unplug the power cord from the wall outlet and, while holding the
ON/STANDBY
key depressed, plug the power cord again. This initializes
the microcomputer. Note that this clears the previously stored memory.
INVISIBLE LASER RADIATION
WHEN OPEN. AVOID EXPOSURE
TO BEAM.
Inside this laser product, laser diodes classified as
Class 3A and 3B laser radiation are contained as
alerted by the internal caution label shown above.
u163
To avoid exposure to laser beams, do not open the
cover.
.
2 9
9 4
2 8
1 5
0 5
8
2 9
9 4
CAUTION
m
co
9 9
2 8
9 9
Advertisement
