Table of Contents
Advertisement
1.5
DISASSEMBLY OF 0 E VF ASSEMBLY
1.5.1 0E VF assembly
Note5a: When disassembling the E VF assembly, remove
the frame (VF) from the case assembly depending
on the situation.
Note5b: Be very careful not to get the inside of the VF soiled
or dusty during and after disassembling the E VF
assembly.
Note5c: After the screw having the loose-proof tip was once
removed from the E VF assembly, don't reuse it.
1. Remove the eyecup and pull out the guide (VF).
2. Draw the frame (VF) out of the case assembly.
<Case assembly>
3. Remove the screw (1) first and then lever (VF).
4. Remove the three screws (2-4) and draw out the eyepiece
B/L SUB ASSY
NOTE
d
5
FFC
FRAME(VF)
EYE PIECE
SUB ASSY
NOTE
5
e
(L
a)
5
5
a
HOLDER
(L
b)
5
NOTE
f
5
LCD MODULE
Fig. 1-5-1
sub assembly.
<Frame (VF)>
5. Remove the screw (5) first and then LCD module/holder
(LCD).
Note5d: Pay heed to the FFC not to damage it during the
removing work.
6. Get the two hooks (L5a, L5b) disengaged and then
remove the holder (LCD).
Note5e: Carefully proceed with the above-mentioned work
not to damage any part.
7. Disconnect the connector (a) and remove the LCD module.
Note5f: Pay heed the parts not to damage any thing.
GUIDE(VF)
2
CASE/CAP
3
1
(LCD)
: 0.069N·m (0.7kgf·cm)
: 0.098N·m (1.0kgf·cm)
EYE CUP
6
7
CAP
(VF)
4
1-9
Advertisement
Table of Contents
