Download Print this page

Troubleshooting Chart - World Dryer AIRFORCE Operating Instructions Manual

High efficiency hand dryer

Advertisement

Operating Instructions and Parts Manual
WORLD DRYER AIRFORCE™
High Efficiency Hand Dryer

Troubleshooting Chart

Symptom
Dryer fails to start.
Dryer will not shut off
or runs 20 seconds,
then will not re-start.
LIMITED WARRANTY
World LIMITED THREE – YEAR WARRANTY. World Warm Air Hair Dryer, Model covered in this manual, is warranted by World Dryer
Corporation to the original user against defects in workmanship or materials under normal use for 3 years after date of purchase. Any part which is
determined to be defective in material or workmanship and returned to an authorized service location, as World designates, shipping costs prepaid,
will be, as the exclusive remedy, repaired or replaced at World's option. For limited warranty claim procedures, see PROMPT DISPOSITION
below. This limited warranty gives purchasers specific rights from jurisdiction to jurisdiction.
LIMITATION OF LIABILITY.
expressly disclaimed. World's liability in all events is limited to and shall not exceed the purchase price paid.
WARRANTY DISCLAIMER. World has made a diligent effort to provide product information and illustrate the products in this literature
accurately; however, such information and illustrations are for the sole purpose of identification, and do not express or imply a warranty that the
products are MERCHANTABLE, or FIT FOR A PARTICULAR PURPOSE, or that the products will necessary conform to the illustrations or
descriptions. Except as provided below, no warranty or affirmation on fact, expressed or implied, other than as stated in the "LIMITED
WARRANTY" above is made or authorized by World.
PRODUCT SUITABILITY.
for certain purposes, which may vary from those in neighboring areas. While World attempts to assure that the products comply with such codes, it
cannot guarantee compliance, and cannot be responsible for how the product is installed or used. Before purchase and use of a product, review the
product application, and all applicable national and local codes and regulations, and be sure that the product, installation, and use will comply with
them.
Certain aspects of disclaimers are not applicable to consumer products; e.g., (a) some jurisdictions do not allow the exclusion or limitation of
incidental or consequential damages, so the above limitation or exclusion may not apply to you; (b) also, some jurisdictions do not allow a limitation
on how long an implied warranty lasts, consequentially the above limitation may not apply to you; and (c) by law, during the period of this Limited
Warranty, and implied warranties of implied merchantability or fitness for particular purpose applicable to consumer products purchased by
consumers, may not be excluded or otherwise disclaimed.
PROMPT DISPOSITION.
proves to be defective within limited warranty. For any product believed to be defective within limited warranty, first write or call dealer from
whom the product was purchased. Dealer will give additional directions. If unable to resolve satisfactorily, write to World at address below, giving
dealer's name, address, date, and number of dealer's invoice, and describing the nature of defect. Title and risk of loss pass to buyer on delivery to
common carrier. If product was damaged in transit to you, file claim with carrier.
Manufactured by World Dryer Corporation
Berkeley, Illinois 60163 U.S.A.
Possible Cause(s)
A) No power to unit.
B) Defective motor.
Sensor is dirty, defective
or there is a reflection.
To the extent allowable under applicable law, World's liability for consequential and incidental damages is
Many jurisdictions have codes and regulations governing sales, construction, installation, and/or use of products
World will make a good faith effort for prompt correction or other adjustment with respect to any product which
Corrective Action
Check power to unit and connections.
Replace motor.
1. Check infra-red eye for dirt or
damage. Use plastic lenses cleaning
solution and a soft cloth. Dry lens with
a soft cloth.
2. Make sure that sensor is not getting
a reflection from another object.
3. After electricity has been applied to
the dryer, it should turn on within few
seconds. Test by placing hands 3 to 6
inches below the nozzle.
4. Replace circuit boards.
6
J4

Advertisement

loading