Connecting The Drain Hose; Connecting To The Power Supply - Kenmore 796.4138 series Use & Care Manual

CONNECTING THE DRAIN HOSE
-The drain hose should always be properly secured.
Failure to properly secure the drain hose can result in
flooding and propert¢ damage.
• Do not install the end of the drain hose higher than 96
in. (243.8 cm) above the bottom of the washer.
"The drain must be installed in accordance with any
applicable local codes and regulations.
-Make sure that the drain hose is not stretched, pinched,
crushed, or kinked.
NOTE:
A drain hoseextensionkit is
available if the drain hoseisnot
long enc___h. D o not extend the
drain hosemore than 6 feet,as
this will cause pcx_ draining,
which will _lt in poor wash
and spin performar_:e.
Option 1: Standpipe
rain Hose
Install the end of the drain hose into the elbow bracket.
Do not extend the drain hose more than 4 inches past the
end of the elbow bracket. Use a tie strap to secure the
drain hose in place.
NOTE:
• Total height of the hose end should not exceed 96 in.
(243.8 cm) from the bottom of the washer.
-The drain hose should be inserted no more than 8-t2
inches into the standpipe. Inserting more than 8-12
inches can cause mold or microorganisms to spread to
the inside of the washer.
If the water valves and drain are built
into the wall, fasten the drain hose
to one of the water hoses with the tie
strap (ribbed side on inside).
/
Tie Strap
Option 2: Laundry Tub
Drain Hose
The elbow bracket should be installed near the end of
the drain hose. Hang the end of the drain hose over the
side of the utility sink. Use a tie strap to secure the drain
hose in place.
Option 3: Floor Drain
Dra;n Hose
Floor Draln
Insert the end of the drain hose into the floor drain.
if possible, secure the hose to prevent it from moving or
coming out of the drain.
CONNECTING TO THE POWER SUPPLY
"Washer should be p_ugged into a 120-VAC, 60-Hz
grounded 3_prong outlet. Plug in the washer.
10