Wipe the base station, charging cradle and
handset with a damp cloth (do not use solvent)
or an antistatic cloth.
Never use a dry cloth. This can cause static.
Contact with liquid
If the handset has come into contact with liquid:
1. Switch off the handset and remove the bat-
tery pack immediately.
2. Allow the liquid to drain from the handset.
3. Pat all parts dry, then place the handset with
the battery compartment open and the keypad
facing down in a dry, warm place for at least
72 hours (not in a microwave, oven etc.).
4. Do not switch on the handset again until it is
When it has fully dried out, you will normally be
able to use it again.
Questions and answers
If you have any queries about the use of
your phone, you can contact us any time at
The table below contains a list of common
problems and possible solutions.
The handset is not
appears in the
Battery pack is
No reaction to
The key lock is
The handset is
outside the range
the base sta-
of the base sta-
flashes in the
The handset is not
The base station is
not switched on.
Cords not routed
Press the end call key
for approx. 5 sec.
or place the handset
in the base station.
battery pack (page 4).
Press the hash key
for approx. 2 sec.
Move the handset
closer to the base
Register the handset
Check the power con-
nector at the base sta-
tion (page 3).
Check cord routing
Service (Customer Care)
We offer you support that is fast and tailored to
your specific needs!
Our Online Support on the Internet can be reached
any time from anywhere.
It provides you with 24/7 support for all our prod-
ucts. It also provides a list of FAQs and answers plus
user guides and current software updates (if avail-
able for the product) for you to download.
You will also find frequently asked questions and
answers in the appendix of this user guide.
For personal advice on our range of products and
assistance with repairs or guarantee/warranty
claims you can contact us on:
UK helpdesk: 0 84 53 67 08 12.
Please have your proof of purchase ready when
calling with regard to guarantee/warranty claims.
Replacement or repair services are not offered in
countries where our product is not sold by author-
This device is intended for analogue phone lines in
Country-specific requirements have been taken
We, Siemens Home and Office Communication
Devices GmbH & Co. KG, declare that this device
meets the essential requirements and other
relevant regulations laid down in Directive 1999/5/
A copy of the 1999/5/EC Declaration of Conformity
is available at this Internet address: