Summary of Contents for Vax quicklife widetrack2 V-045
Page 1
Vax V-045N User Guide.qxd:V-112P User Guide 22/5/08 12:21 Page 1 Vax careline 0870 6061248 Bagless upright vacuum Vax model number: V-045 V-045S V-045N Please read carefully before using this cleaner. www.vax.co.uk Always fully extend the mains cable before use. Retain for future reference.
If the supply cord or plug is vacuum cleaner. damaged, return the vacuum cleaner to a Vax Authorised Service Agent or suitably qualified IMPORTANT: Cleaning filters improves vacuum person for examination, repair or adjustment.
Vax V-045N User Guide.qxd:V-112P User Guide 22/5/08 12:21 Page 4 www.vax.co.uk 3. How to Assemble IMPORTANT: Always remove the power plug from the electrical outlet before assembling or removing accessories. Assembling the Vacuum Cleaner Insert the telescopic tube into the hole on the top of the unit.
Vax V-045N User Guide.qxd:V-112P User Guide 22/5/08 12:21 Page 5 Vax Careline 0870 606 1248 4. How to Operate Fully unwind the power cord. Plug the cord into an electrical outlet. Turn the vacuum cleaner on by pressing the on/off switch located on the lower right side of the cleaner (Fig.4/1).
Page 6
The vacuum cleaner must be in the upright position to lift the rotating brushbar off the carpet when using the accessories. Vax recommend that the carpet height adjuster is at its highest setting. Fig.5/2...
Vax V-045N User Guide.qxd:V-112P User Guide 22/5/08 12:21 Page 7 Vax Careline 0870 606 1248 6. Dirt Container & Filter: Removal and Replacement IMPORTANT: Always unplug the unit from the electrical outlet before opening the dirt container. IMPORTANT: Do NOT use the vacuum without the HEPA filter in place.
Page 8
To remove the exhaust filter, twist the pre-motor filter cover, then remove the exhaust filter (Fig.6/10). Fig.6/7 Vax recommends washing the HEPA filter once a month, or when suction appears reduced. Always allow the filter to air dry for 24 hours before Fig.6/10...
• After unit has cooled down for 45 minutes, plug in the cleaner and push the on/off button. The vacuum should start again. • If the vacuum still does not start, contact Vax Care 0870 606 1248. Cleaning & Changing the Belt...
Vax V-045N User Guide.qxd:V-112P User Guide 22/5/08 12:21 Page 10 www.vax.co.uk Press firmly to ensure each end is completely inserted. 9. Troubleshooting Check to make sure the belt is centred on the agitator WARNING: To reduce the risk of personal injury, pulley and that the brushbar turns.
Please make a note of the serial number and model Cause: Belt installed incorrectly. number of the carpet cleaner before calling. There are over 400 approved Vax Service Agents in the UK. For the Solution: Check belt changing and brushbar cleaning nearest Service Agent, please call the Vax Careline.
Page 12
22/5/08 12:21 Page 12 EEC STATEMENT OF COMPLIANCE Manufacturer/EEC importer: Vax Limited, hereby on our own responsibility, declare that the V-045 Range is manufactured in compliance with the following Directives: Safety: 2006/95/EC Low Voltage Directive EMC: 2004/108/EC Electromagnetic Compatibility Directive Waste electrical products should not be disposed of with household waste.