Drive Manual Operation; Drive Manual Operation Wnu Creen; Disc Type; Manual Control 1 - Sony dvp-s3000 Service Manual

6-4. Drive Manual Operation

In performing manual operation, observe the following points:
Select correct disc type on the Disc Type screen.
First, select "7. Check" and execute "4. Hydet init" and "5. Sled
init". (See Figure 9)
With the initial menu displayed, if [2] on standard commander is
pressed, the screen shown in Figure 11 is displayed.
In case of abnormality, press [stop] immediately to stop operation
and turn off the power.
Do not execute Auto Adjust while executing FG Pause.
Also, as these commands are not protected, take care not to press
wrong key.
6-4-1. Drive Manual Operation Menu Screen
Drive Manual Operation
SA.000000 SI.00

0. Disc Type

1. Manual Control 1

2. Manual Control 2
3. Manual Control 3
4. Manual Adjust 1
5. Manual Adjust 2
6. Auto Adjust
7. Check
Figure 8
This screen provides a menu for manual operation, and you can go
directly to each screen from here. To return to this screen from each
screen, press the RETURN key.
For switching between respective screens, use the CLEAR key.
check
SA.000000 SI.00
0. SRAM Check
1. EEPRM Check
2. CDDET Check
3. EPROM Default
4. Hydet Init
5. Sled Init
6. EEPROM Data
Figure 9
EMG.00
EMG.00
6-13
6-4-2. Disc Type
Disk type
SA.000000 SI.00
0. DVD SL 12cm
1. CD 12cm
2. DVD DL 12cm
3. DVD SL 8cm
4. CD 8cm
5. DVD DL 8cm
6. Disc type check
DVD SL 12cm
Figure 10
On this screen, select the type of disc used.
"6. Disc type check" judges the disc loaded. Confirm that judgment
result meets the loaded disc type.
Judgment may fail if adjustment is not made yet immediately after
EEPROM Default Set. The CD which is not cut up to the CD/VDV
detection sensor position is judged as DVD. The optical system
will be damaged if other disc is loaded after selecting DVD DL.
6-4-3. Manual Control 1
Manual Control 1
SA.000000 SI.00
0. LD off
1. SP off
2. Tilt off
3. Focus off
4. Brake off
5. Track off
6. Sled off
DVD SL 12cm
Figure 11
On this screen, turn on/off servo operation items necessary for play-
ing.
Normally, turn on the items from 1 sequentially, and normal trace is
executed at CLVA. For the Brake, turn it off after turning on the
Sled. During normal operation, AGC is turned on.
EMG.00
EMG.00
7. CLVS
8. CLVA
9. FG
n. Sled FWD
N. Sled RVS
. Tilt Up
. Tilt Down