Manual Installation - D-Link DCS-934L User Manual

Section 2 - Installation
If you prefer to set up your camera without using the Camera Setup Wizard, follow the steps below.
Note: In order to use the mydlink features of this product, you should use either the Camera Setup Wizard or Zero Configuration Setup.
To learn more about mydlink, refer to
Connect the Power Cable and Ethernet Cable
Step 1
Attach the power supply to the power receptor located on the back of the DCS-934L and
connect it to a wall outlet or power strip. Power is confirmed when the Power LED is lit.
Step 2
If using an Ethernet connection, connect the included Ethernet cable to the Ethernet port
on the back of the camera. Plug the other end into an available port on your router.
If your router supports Wi-Fi Protected Setup, you can initiate a wireless connection with
your router using WPS. Refer to
Configure Your Camera
Step 3
Refer to "Configuration" on page 25
D-Link DCS-934L User Manual

Manual Installation

"What is mydlink?" on page
"WPS - Push Button Setup" on page
for instructions on how to configure your camera.
24.
21.
20