Installation Diagram Of Indoor And Outdoor Units - Toshiba RAS-(B)10UFV Series Installation Manual

INSTALLATION DIAGRAM OF INDOOR AND OUTDOOR UNITS

INSTALLATION DIAGRAM OF INDOOR AND OUTDOOR UNITS
Air fi lter
6
Filter
5
Filter
3
Batteries
2
Wireless remote control
7 9
Mounting screw
Optional Installation Parts
Part
Parts name
code
Refrigerant piping
Liquid side : ∅6.35 mm
: ∅9.52 mm
Gas side
A
(RAS-(B) 10, 13UFV Series)
: ∅12.7 mm
(RAS-(B) 18UFV Series)
Pipe insulating material
B
(polyethylene foam, 8 mm thick)
C
Putty, PVC tapes
1
50 mm or more
8
Pan head
wood screw
Insulation sheet
600 mm or more only
when unobstructed
to the front and both
sides.
(C)
(B)
Q'ty
One
each
1
One
each
Installation plate
50 mm or more
Shield pipe
4
Remote control holder
Vinyl tape
Apply after carrying
out a drainage test.
(D)
Extension
drain hose
(Not available,
provided by installer)
(A)
Fixing bolt arrangement of outdoor unit
RAS-10, 13, 18SAV Series
• Secure the outdoor unit with fi xing bolts and nuts if the unit is likely to be exposed
to a strong wind.
• Use ∅8 mm or ∅10 mm anchor bolts and nuts.
• If it is necessary to drain the defrost water, attach drain nipple and cap water proof
to the bottom plate of the outdoor unit before installing it.
108 mm
28 mm
Air outlet
600 mm
X When using a multi-system outdoor unit is used, refer to the installation manual
provided with the model concerned.
3
Do not allow the drain hose to get
slack.
Make sure to run the drain hose
sloped downward.
The auxiliary piping can be
connected to the left, rear left, rear
right, right, bottom right or bottom
left.
Right
Rear right
Bottom right
Insulate the refrigerant pipes
separately with insulation, not
together.
8 mm thick heat resisting
polyethylene foam
Saddle
In case of right or left piping
125 mm
Air inlet
* Drain nipple and cap
water proof are packed
in outdoor unit.
90 mm
Drain outlet
Cut the piping
hole sloped
slightly.
Left
Rear left
Bottom left
Cut dot-line area