Setting Up The Hardware; Installing The Battery - Uniden MHS155UV Owner's Manual

Setting up the Hardware

Attaching the Antenna
The antenna detaches from the radio for easy shipping or storage. To
attach the antenna to your radio, screw it tightly onto the anchor post at
the top of the radio.

Installing the Battery

Your radio uses the supplied Lithium Ion battery pack. To install the
Lithium Ion battery pack:
1. Remove the belt clip if installed.
2. Use a screwdriver to turn the battery compartment screw
counterclockwise and then lift up and remove the battery cover.
3. Line up the new battery's connector with the jack inside the battery
compartment (the connector only fits one way).
4. Push the connector in firmly. Tug on the battery wires gently to make
sure you have a good connection.
5. Before replacing the battery cover, check the rubber seal located
on the under side of the cover; make sure that the seal is set in the
groove and that there is no foreign matter under the seal.
6. Replace the battery compartment cover. Tighten the screw securely.
If the rubber seal appears warn, nicked, or dried out, you
must replace it. If the seal looks worn or damaged, contact
customer service to order a replacement (see front cover
NOTE
page for contact information).
Installing Alkaline Batteries
When using Alkaline batteries, transmit power is limited to
MID or LOW power.
NOTE
The radio also comes with an accessory battery tray that holds four AAA-
type Alkaline batteries (not included).
Follow these steps to use the accessory battery tray:
1. Align the batteries' positive and negative terminals with the markings
on the case and snap each battery into place.
UNIDEN MHS155UV
12
UHF CB+VHF Marine Radio