Adjusting Line Length - Canon iPF785 Series Basic Manual

iPF785 Series
7
Press ▲ or ▼ to select Automatic, Print Quality, or Print Length, and then press the OK button.

Adjusting Line Length

Adjusting Line Length
To ensure that lines in CAD drawings are printed at exactly the right length, use Adjust Length to adjust the
amount that paper is advanced.
There are two options in Adjust Length : AdjustmentPrint and Change Settings.
AdjustmentPrint
•
After a test pattern is printed, you will measure the discrepancy based on the results of printing.
Change Settings
•
No test pattern is printed. Instead, you will measure a document already printed to determine the discrepancy.
Additionally, two modes are available in both AdjustmentPrint and Change Settings : A:High or B:Standard/
Draft. Choose the mode that suits your particular printing application.
A:High
•
This setting is applied when Highest or High is selected in Print Quality in the printer driver.
B:Standard/Draft
•
This setting is applied when Standard or Fast is selected in Print Quality in the printer driver.
• Always check the Adj. Priority values before using Adjust Length. (See "Selecting a Feed Amount Adjustment
Method.")
P.82
➔
Note
• Use paper of the same type and size for adjustment as you will use for printing.
Paper to Prepare
When Using Rolls
•
•
When Using Sheets
•
•
Perform adjustment as follows.
1
Load the paper.
Attaching the Roll Holder to Rolls
•
Loading Rolls in the Printer
•
Loading Sheets in the Printer
•
• Always make sure the loaded paper matches the type of paper specified. Adjustment cannot be comple-
ted correctly unless the loaded paper matches the settings.
Important
2
On the Tab Selection screen of the Control Panel, press ◀ or
▶ to select the Settings/Adj. tab (
• If the Tab Selection screen is not displayed, press the Menu button.
Note
3
Press the OK button.
The Set./Adj. Menu is displayed.
Basic Guide
An unused roll at least 10 inches wide
High-precision ruler
One sheet of unused paper of at least A4/Letter size
High-precision ruler
P.12
➔
P.15
➔
P.21
➔
).
Adjusting Line Length
83